Midi System Exclusive
Poly Cinematic can receive sysex messages over midi to allow chords to
be programmed to the memory slots without the need for a keyboard and
without audibly playing back the notes."
Stereo
Poly Cinematic has a stereo output because it has a 24bit stereo reverb
built in. The unit can still be used in a mono signal chain using either the
Left or Right output alone."
Installation
Poly Cinematic requires a -12v/+12v eurorack power source and draws
80mA. When the unit is powered up correctly the Trigger button will glow
slightly."
Trouble Shooting
If there is no sound at the outputs:"
• Disconnect all cv and gate inputs."
• Check there is power going to the unit, the Trigger button should be
dimly lit when the unit is correctly powered up."
• Press the Trigger button to test for a sound, the button should light up
brightly when a note is sounded."
• Check that the filter isn't blocking the sound, set to Notch mode."
• Check the envelope Attack isn't too long or the Decay isn't too short."
• Check for sound with a simple set of 3.5mm headphones to rule out
other output chain issues. "
• If none of the above work, Perform a factory reset (see above) and press
the Trigger button again."
Support
Support can be found on our website at https://www.knobula.com/forum."
Or email support@knobula.com."
To Previous Page
Loading...