Knoll Reff Profiles 6TP00587

To Next Page

Wall Mount Height Adjustable Table

Reference Number: 6TP00587

Reff Proﬁles

™

Installation Instruction

Reff Proles

™

December 20, 2019

Part Number: 6TP00587

Sheet a

Table of Contents

Position Mid Gable if Table is 72”

or Wider. Skip Step 34 if Table is Under 72” Wide 27

Safety First & Assembly & Adjustment 1-9

Pattern Numbers Represented / Tools Needed / Part List 10

Construct Base Assembly 11-12

Assemble Notched Top and Attach Bracketry 13-16

Prepare and Attach Gables 17

Prepare Mid Gable if Table is 72” or Wider

Skip Steps 18 & 19 (sheet 9) if Table is Under 72” Wide 18

Attach End Gable 19

Wall Mounting Suggestions 20-21

Position and Secure Basea 22-23

Electrify Base 24

Install Worksurface Top 25

Affix Handset 25

Prepare the Frontset for Attachment 26

Attach Frontset 28-30

Main Page

Need help?

Do you have a question about the Knoll Reff Profiles 6TP00587 and is the answer not in the manual?

Summary

Important Information and Safety

Important Safety Instructions

Details safety warnings, DANGER, WARNING, CAUTION, and NOTICE definitions for table operation.

User Information

Provides load capacity, motor duty cycle limits, and general user guidance.

Before You Start

Instructions on checking for obstacles and performing a manual reset before initial use.

Electrical Rating

Specifies the input and output electrical ratings for the table system.

Assembly and Adjustment Guide

Assembly Instructions

General guidance for assembling the height adjustable table base components.

Setup Procedure

Step-by-step instructions for connecting electrical components and setting up the table.

Optional Mounting Guidelines

Guidelines and warnings related to mounting the table and electrical safety.

System Configuration Example

Illustrates the typical configuration of power supply, bus cable, and handset.

Adjustment Information

Notes on sealed units and contacting the vendor for adjustments or maintenance.

Construct Base Assembly

Instructions for constructing the primary base structure of the height adjustable table.

Assemble Notched Top and Attach Bracketry

Steps to assemble the notched top and attach necessary bracketry to the base.

Prepare and Attach Gables

Procedure for preparing and attaching the end and mid gables to the table base.

Attach End Gable

Detailed steps for attaching the end gables to the assembled table base.

Wall Mounting Suggestions

Recommendations and considerations for securely mounting the table to a wall structure.

Position and Secure Base

Guidance on positioning the table base correctly and securing it to the wall.

Electrify Base

Steps to connect the power supply, iDrive cables, and handset for table operation.

Install Worksurface Top

Instructions for attaching the worksurface top to the assembled table base.

Affix Handset

Procedure for mounting the handset controller to the underside of the worksurface.

Prepare Frontset for Attachment

Steps to prepare the frontset component with multi-clips for attachment to the table.

Position Mid Gable for Wider Tables

Specific instructions for positioning the mid gable for tables of 72 inches or wider.

Attach Frontset

Steps for attaching the hinged frontset to the end gables and mid gable.