Machine Tools OPERATING INSTRUCTIONS
23
8.5、The empty block of spindle
Take the spindle speed change handle 10 to the “0” position , then you can turning the Spindle
easily by hand . Notice ;You must stop before change the speed .
8.6、Spindle feeding
Organism feeding—pull the Handle 12 out., then spindle feeding automatically .
Manual work feeding ----push the Handle 12 in and turning handle 12, it can let the spindle
accessing up and down. .
Slight feeding ---Let the feeding speed change Handle 11 to the “0” position and pull Handle 12
out, turning the Handle 19 and then slight accessing .
Notice ：Do not exceed the limitation position of up and down distance when spindle feeding (spindle
distance 240mm), otherwise plain axis easily destroied。
To Previous Page
Loading...