KNX GIRA Quick Start Guide

Dimming actuator, 4-gang
– Continuous manual mode: Exclusively manual operation on the device
No bus operation is possible in manual mode.
After a bus failure and restoration the device switches to bus operation.
The manual mode can be disabled in ongoing operation via a bus telegram.
Switching on the temporary manual control
Operation using the button field is programmed and not disabled.
￭ Press button ǃ (6) briefly.
LED ǃ (7) flashes, LED
A1...
(4) of the first configured output flashes.
Short-time manual operation is switched on.
After 5 s without a key-press, the actuator returns automatically to bus operation.
Switching off temporary manual operation
The device is in short-term manual mode.
￭ No button-press for 5 s.
- or -
￭ Press ǃ (6) button briefly as many time as necessary until the actuator leaves the
short-time manual mode.
Status LED
A1...
(4) no longer flash, but rather indicate the output status.
Short-time manual operation is switched off.
When switching off the manual control, the outputs, depending on the programming,
switch to the active position, e.g. forced position, logic operation.
Switching on permanent manual control
Operation using the button field is programmed and not disabled.
￭ Press the ǃ (6) button for at least 5 s.
LED ǃ (7) lights, LED
A1...
(4) of the first configured output flashes.
Continuous manual mode is switched on.
Switching off permanent manual control
The device is in continuous manual mode.
￭ Press the ǃ (6) button for at least 5 s.
LED ǃ (7) is off.
Continuous manual mode is switched off. Bus operation is switched on.
When switching off the manual control, the outputs, depending on the programming,
switch to the active position, e.g. forced position, logic operation.
Operating the outputs
The device is in continuous or short-term manual mode.
￭ Press the button ǃ (6) briefly as many times as necessary until the desired output is se-
lected.
The LED of the selected output
A1...
(4) flashes.
The LEDs
ON|+
(8) and
OFF|−
(11) indicate the status.
￭ Operate output with
ON|+
(9) button or
OFF|−
(10) button.
Short: switch on/off.
Long: dim brighter/darker.
Release: Stop dimming.
The LEDs
ON|+
(8) and
OFF|−
(11) indicate the status.
4 / 11
82402712 10.07.2020

KNX GIRA Specifications

General

Protection Class	IP20
Ambient Temperature	-5 °C to +45 °C
Communication Protocol	KNX
Mounting	DIN Rail
Number of Channels	Depends on model