13
OPERATING INSTRUCTIONS
12. Removing Bits
a. Lock the trigger switch by placing the direction-of
rotation selector (D) in the OFF (center) position.
b. Pull the sleeve (A) towards the front of the tool
and hold it in place.
c. Remove the bit from the hexagonal hole in the bit
retainer.
d. Release the sleeve.
13. Tightening and Loosening Screws and Nuts
a. Install the correct bit.
b. Apply just enough pressure to keep the bit engaged on the screw or nut.
c. Apply minimal pressure to the trigger switch (A) initially. Increase the speed only when you can
maintain full control.
WARNING: Do not overtighten, as the force of the impact driver can break the fastener. Keep
the Impact driver at a right angle to the fastener to avoid damaging the fastener head.
12
A
D
To Next Page
Loading...
Need help?
General
