4
SYMBOLS
Some of the following symbols may be used on this product. Please study them and learn their
meaning. Proper interpretation of these symbols will allow you to operate the product better and
safer.
SYMBOLS NAME DESIGNATION/EXPLANATION
V Volts Voltage
A Amperes Current
Hz Hertz Frequency (cycles per second)
~ Alternating Current Type or a characteristic of current
Class II Construction Double-insulated construction
RPM Rotating Speed Revolutions per minute
/min Per Minute Revolutions, strokes, surface speed, orbits, etc., per minute
Ear Protection
Always wear ear protection.
Read The Operator’s
Manual
To reduce the risk of injury, user must read and understand
operator’s manual before using this product.
Eye Protection
Always wear eye protection with side shields marked to
comply with ANSI Z87.1.
Safety Alert Precautions that involve your safety.
The chain bar tip
Contact of the chain bar tip with any object should be
avoided.
Tip contact
Tip contact can cause the chain bar to move suddenly
upward and backward, which can cause serious injury.
Two hands Always use two hands when operating the chain saw.
The power
Always keep the power cable away from heat sources, oils
or sharp edges. Immediately remove plug from the mains if
the cable is damaged or entangled.
Wet Conditions Alert Do not expose to rain or use in damp locations.
To Next Page
Loading...
Need help?
General
