12
OPERATING INSTRUCTIONS
To Remove the Bail Handle
1. Remove battery pack.
2. Loosen the screws with the hex wrench and
remove the bail handle.
6. Inlet Vent Guard
Using the inlet-vent guard (C) will increase the
performance and extend the life of the tool.
a. To remove the inlet-vent guard, insert a at
screwdriver (not included) into the notch at
the top of the inlet-vent guard, and pry it away
from the tool.
b. To attach the inlet-vent guard, snap the guard
into the tool’s foot.
Clean the Inlet-Vent Guard
To clean the inlet-vent guard, tap it against a hard
surface, or blow it clean with compressed air.
WARNING
• Always wear goggles when using compressed air to clean power tools.
• To reduce the risk of injury, wear safety goggles or glasses with side shields.
7. Installing Polishing Pads
The polisher is shipped with three pads, each
designed for specic applications.
Yellow Pad: For removing severe oxidation,
abrasions, and scratches with abrasive
compounds.
Blue Pad: For heavy polishing with cleaning
waxes, one-step polishers, or “all-in-one” products.
Black Pad: Finishing surfaces to remove swirls and
apply thin coats of wax, sealants, and glazes.
Selecting the correct size grit and type polishing
pad is an extremely important step in achieving a
high-quality nish.
5b
7
6
C
F
To Next Page
Loading...
Need help?
General
