21
CARE AND MAINTENANCE
Chain Oiler
WARNING
To avoid possible serious injury, stop the motor and
remove the battery from the pole saw before replacing the
bar, chain or performing any maintenance operation.
• Use Premium Bar and Chain Lubricant. It is designed for
chains and chain oilers and is formulated to perform over
a wide temperature range with no dilution required.
• Remove the cap (K) and carefully pour into the bar lube
reservoir.
• Replace the cap and tighten securely.
• Check and rell the bar lube reservoir every time the pole
saw is used.
Note:
Do not use dirty, used or otherwise contaminated
lubricants. Damage may occur to the oil pump, bar or
chain.
Bar Lube Reservoir
K
To Next Page
Loading...
Need help?
General
