6
SYMBOLS
Some of the following symbols may be used on this product. Please study them and learn their
meaning. Proper interpretation of these symbols will allow you to operate the product better and safer.
SYMBOL DESIGNATION EXPLANATION
V Volts Voltage
A Amperes Current
Hz Hertz Frequency (cycles per second)
W Watt Power
n
o
No Load Speed Rational speed, at no load
/min Per Minute Revolutions, strokes, surface speed, orbits etc., per minute
Direct Current Type or a characteristic of current
Read the Operator’s
Manual
To reduce the risk of injury, user must read and understand
operator’s manual before using this product.
Safety Alert Precautions that involve your safety.
Wet Conditions Alert Do not expose to rain or use in damp locations
Ear Protection Wear ear protection when operating this equipment.
Eye and Head
Protection
Wear eye and head protection when operating this
equipment.
Gloves
Wear non-slip, heavy-duty protective gloves when handling
the chain saw and the blade.
Safety Footwear Wear non-slip safety footwear when using this equipment.
Kickback
Tip contact can cause the guide bar to move suddenly
upward and backward, which can cause serious injury.
Risk of Electrocution/
Keep Bystanders
Away
DANGER! Risk of electrocution! Keep tool 50 ft. away from
electrical lines. Keep all bystanders at least 50 ft. away.
Electric Shock
Failure to use in dry conditions and to observe
safe practices can result in electric shock.
To Next Page
Loading...
Need help?
General
