15
OPERATING INSTRUCTIONS
To Start the Snow Blower (Fig. 5)
a. Ensure that the handlebar assembly securely
locked in the unfolded, open position.
b. Attach the battery pack(s) to the snow blower
and close the battery cover as described in the
chapter “4. To Attach/Detach Battery Pack”.
c. Depress the safety button (A).
d. With the safety button (A) depressed and hold
for more than 0.3 second, pull the bail switch
(B) to meet the handlebar (C).
e. Once the tool powers on, release the safety
button and begin operation.
NOTICE: The tool is started by depressing the
safety button rst, followed by squeezing the bail
switch; the reverse operation will not start the tool.
NOTICE: The snow blower may not properly start if its battery temperature is -4°F (-20°C) or
less. If unit doesn’t start, remove the battery pack(s) from the snow blower and allow it/them to
warm indoors for 10 minutes or longer. Reinstall the battery pack and try again.
To Stop the Snow Blower
a. Fully release the bail switch.
b. The electric brake in the Automatic Braking Mechanism will stop the auger rotation within 3
seconds of the bail-switch release.
6. Variable-Auger-Speed System (Fig. 6)
The speed of the auger can be adjusted to control
the throwing distance.
a. To increase the speed, move the auger-speed
control lever (D) forwards.
b. To decrease the speed, move the variable-
auger-speed adjustment backwards.
5
C
B
A
6
D
To Next Page
Loading...
Need help?
General
