Kobalt SC2502LW - Page 21

21
un
11
INSTALLING/REMOVING THE REAR TABLE
EXTENSION (FIG. 11) - BAG X
Move the sliding table to its most forward position
and lock in place.
To install the rear table extension:
● Insert the tab (1) on the front of the rear
table extension (D) under the sliding table
and insert the slot (2) on the front of the
rear table extension (D) into the tab on the
sliding table
.
● Insert the side tab (3) on the left side of the
rear table extension (D) into the slot (4).
● Align the hole (5) of the rear table
extension (D) with the hole (6) on sliding
table.
● Secure by threading the rear table extension
lock knob (RR) through the washer (tt) into
the hole (6) located on right side of table.
NOTE: Make sure that the table insert on the
rear table extension is aligned with the table
insert on the sliding table.
To remove the rear table extension:
● Loosen the rear table extension lock
knob (RR) and then remove the knob and
the washer (tt).
● Pull the tab (3) out of the slot (4)
and pull
the tab (1) and slot (2) out of the sliding
table, and then remove the the rear table
extension (D).
3
4
2
1
D
6
5
tt
RR
Front