22
RAISING AND LOWERING THE CUTTING
HEAD ASSEMBLY (FIG. 12, 13)
Raising the cutting head assembly (Fig. 12)
● Pull out the hold-down latch (SS).
● Grasp the motor handle (KK) to raise up the
cutting head to a vertical position, and then
release the hold-down latch (SS). Tighten
the cutting head lock knob (MM).
● Pull out the arm folding lock knob (FF) and
hold the motor handle (KK) to raise up the
cutting head assembly. Push in the arm
folding lock knob (FF) and rotate clockwise
to tighten it.
● Install the rear table extension (D).
12
KK
FF
KK
D
SS
MM
To Next Page
Loading...
