Why can't I adjust the miter on my Kobalt Saw?
If you cannot adjust the miter on your Kobalt Saw and the angle of cut is not accurate, the miter table might be locked. Push the positive stop locking lever down and rotate the table. Also, check for sawdust under the table and vacuum or blow it out, wearing eye protection.
What to do if my Kobalt SM1850LW Saw blade binds, jams, or burns wood?
If your Kobalt Saw blade binds, jams, or burns wood, it could be due to several reasons. First, ensure you are operating the saw correctly. You may need to replace or sharpen the blade if it is dull. Using the wrong size blade can also cause this issue, so replace it with a 7-1/4 inch diameter blade. A warped blade should also be replaced.
Why does my Kobalt Saw vibrate or shake?
If your Kobalt Saw vibrates or shakes, the issue might stem from the saw blade itself. Check if the saw blade is not round, damaged, or warped; if any of these are true, replace the blade. Also, ensure the saw blade is tightened by tightening the arbor bolt.
What to do if my Kobalt SM1850LW motor does not start?
If the motor of your Kobalt Saw does not start, check the 15A time-delay fuse or the circuit breaker. If the brush is worn, see CARE AND MAINTENANCE section.
How to fix a Kobalt Saw when the blade does not stop within 10 seconds?
If the blade of your Kobalt Saw does not stop within 10 seconds, the motor brushes may not be sealed or are lightly sticking. Inspect, clean, and/or replace the brushes. Also, check if the arbor bolt has loosened and retighten it.
What causes excessive brush spark when releasing the switch on my Kobalt Saw?
Excessive brush spark when the switch is released on your Kobalt Saw indicates that the brush is worn. Replace the brushes.
Essential safety guidelines, including Proposition 65 warnings and general precautions for tool use.
Specific safety instructions for operating power tools, emphasizing proper usage and precautions.
Safety rules tailored for compound miter saws, covering blade use and operational hazards.
Details on power supply requirements, double insulation, and electrical safety precautions.
Detailed steps for safely removing the saw blade from the miter saw.
Step-by-step instructions for correctly installing a new saw blade onto the miter saw.
Critical safety warnings and guidelines for operating the laser guide feature.
Pre-operation checks and steps to ensure the saw is ready and safe for use.
Routine inspections and checks to perform before every operation for safety and performance.
Proper positioning of body and hands for safer and easier cutting operations.
General| Soft Start | Yes |
|---|---|
| Table Material | Aluminum |
| Voltage | 120V |
| Type | Miter Saw |
| Motor Power | 15 Amp |
| Arbor Size | 5/8 inches |
| Cord Length | 6 feet |
| Dust Port Size | 1-1/4 inches |
To Next Page