23
Lowering the cutting head assembly (Fig. 13)
● Remove the rear table extension (D).
● Loosen the arm folding lock knob (FF) and
pull it out.
● Grasp the motor handle (KK) to lower the
cutting head assembly backward.
● Release the arm folding lock knob (FF) and
it will lock into the hole automatically to lock
the arm.
● Loosen the cutting head lock knob (MM) and
pull out the hold-down latch (SS). Grasp the
motor handle (KK) to lower the cutting head
clockwise and then release the hold-down
latch (SS) to put it into the locking hole.
NOTE: When storing the saw, the cutting
head assembly should always be folded.
13
KK
MM
SS
FF
KK
D
To Next Page
Loading...
