To Next PageTo Next PageWhy does my Kobalt K15CS-06AC Saw blade bind, jam, or burn the wood?
If the Kobalt Saw blade binds, jams, or burns the wood, it could be due to improper operation. Review the “OPERATING INSTRUCTIONS” section. Also, a dull blade can cause this issue, so replace or sharpen the blade. Finally, an improper blade may be the cause, so replace it with the correct one.
What to do if my Kobalt K15CS-06AC vibrates or shakes?
If your Kobalt Saw vibrates or shakes, it might be due to an improper blade, so replace the blade. Another possible cause is improper installation of the blade. Remove the blade and reinstall it, ensuring no part is missed during reinstallation.
General| Amperage | 15 Amps |
|---|---|
| Arbor Size | 5/8 Inch |
| Cord Length | 6 Feet |
| Dust Port Size | 1-1/4 in. |
| Blade Diameter | 7-1/4 Inches |
| Bevel Capacity | 0-56 Degrees |
Understanding kickback causes and implementing measures to prevent it.
Guidance on saw blade selection, maintenance, and correct installation procedures.
Ensuring the proper function and use of the circular saw's lower blade guard.
Step-by-step instructions for safe and effective circular saw cutting.
Solutions for common issues like blade binding, jamming, or vibration.
