To Next PageTo Next PageWhy does my Kobalt KXCS 124B-03 Saw blade bind, jam, or burn the wood?
If your Kobalt Saw blade binds, jams, or burns the wood, it could be due to improper operation. Refer to the “OPERATING INSTRUCTIONS” section for guidance. Another possible cause is a dull blade. In this case, replace or sharpen the blade.
What to do if my Kobalt KXCS 124B-03 vibrates or shakes?
If your Kobalt Saw vibrates or shakes, it might be due to an improper blade. Try replacing the blade. Alternatively, the blade may not have been installed correctly. Remove the blade and reinstall it, making sure that no part was missed during installation.
Read manual and labels before use for safe operation.
Keep area clean, avoid hazards, general warnings, and electrical safety.
Stay alert, use PPE, prevent unintentional starting, dress properly, tool use, and maintenance.
Recharge, use correct packs, avoid shorting, handle damaged packs, temperature limits.
Cutting procedures, danger of hand contact, not reaching under workpiece.
Sudden reaction to pinched/jammed blade, causes and how to avoid it.
Lower guard checks, special cuts, and additional warnings like dust mask, blades, hearing.
Familiarize with features and safety requirements before use.
Align and secure battery pack onto the tool; press release buttons to remove.
Press lock-off button then squeeze trigger to turn ON; release to turn OFF. Electric brake stops blade.
Keep blades clean, sharp, and properly set; install and remove with care.
Guard protects operator; adjust cutting depth to match material thickness.
Loosen knob, tilt saw to align indicator with scale, tighten knob for desired angle.
Work light illuminates workpiece; install vacuum adapter or edge guide.
General guidance, best practices, cross-cutting, rip cutting, and bevel cutting.
Adjust bevel to 0°, set depth, swing lower guard, guide saw into workpiece.
Remove battery, keep tool clean, use soft dry cloth.
Lists common problems, causes, and corrective actions.
General