To Next PageTo Next PageWhat to do if the blade binds, jams, or burns the wood when using my Kobalt KXRS 124B-03 Saw?
If the blade of your Kobalt Saw binds, jams, or burns the wood, there are a few potential causes. It could be due to improper operation. Refer to the “OPERATING INSTRUCTIONS” section. Another reason may be a dull blade, in which case you should replace or sharpen it. Finally, check if you are using the improper blade and replace it, if needed.
Why is the motor overheating in my Kobalt KXRS 124B-03?
If the motor in your Kobalt Saw is overheating, it's likely because the cooling vents are obstructed. Make sure to clean and clear the vents. Also, avoid covering the vents with your hand while operating the saw.
Lists and describes all parts included in the package with labels A-H.
Covers eye protection, chemical exposure risks, and general tool usage precautions.
Advises reading the manual and tool labels before operation.
States that servicing should only be done by qualified technicians.
Explains the meaning of symbols used in the manual and on the tool.
Advice on keeping the work area clean, avoiding explosive atmospheres, and keeping bystanders away.
Guidelines on plugs, grounding, avoiding wet conditions, and cord care.
Recommendations for using extension cords and RCDs outdoors or in damp areas.
Emphasizes staying alert, using PPE, preventing unintentional starting, and proper attire.
Covers using the correct tool, handling damaged tools, storage, and maintenance of cutting edges.
Instructions for charging, using, and handling battery packs safely.
Guidelines for servicing the tool and battery packs by qualified personnel.
Specific warnings for handling the saw blade, workpiece security, and avoiding contact with hidden wires.
Introduces the tool's purpose and encourages familiarization with features and safety.
Steps for connecting and removing the battery pack, including safety warnings.
Guidance on choosing the correct blade and how to install/remove it.
Explains how to control speed and lock the trigger for safe operation.
Describes the LED light's illumination and its behavior during overload or low battery.
How to adjust the base shoe for control and contact, and its pivoting function.
Explains how to use the orbital action lever for different cutting styles.
Detailed steps for performing general cuts, including safety checks and technique.
Instructions for plunge cutting into surfaces like walls, with safety warnings.
Advice for cutting various metals, including using cutting oil and securing the workpiece.
Instructions on how to clean the tool safely and effectively.
General| Corded/Cordless | Corded |
|---|---|
| Blade Diameter | 12 inch |
| Type | Sliding Compound Miter Saw |
| Amperage | 15 A |
| Blade Size | 12 inch |
| Arbor Size | 1 inch |
| Motor | 15 A |
| Weight | 54.5 lbs |
