To Next PageTo Next PageWhat to do if the movement of sliding table of Kobalt KWS B72-06 is not smooth?
If the sliding table of your Kobalt Saw doesn't move smoothly, it's likely due to debris buildup on the rails. Remove any mud or tile debris from the rails to restore smooth movement.
What to do if my Kobalt KWS B72-06 Saw motor is not running?
If the motor of your Kobalt Saw isn't running, the issue might be a lack of power. You should check the cable, plug, socket, and fuse to ensure they are working correctly.
Why is my Kobalt KWS B72-06 cutting wheel running irregularly or vibrating?
If the cutting wheel of your Kobalt Saw runs irregularly or vibrates, it could be due to two reasons: * The cutting wheel might be warped, in which case you should replace it. * The cutting wheel might not be fitted correctly, so ensure it is properly installed.
Why is the cutting wheel of my Kobalt KWS B72-06 Saw discolored?
A discolored cutting wheel on your Kobalt Saw can result from insufficient cooling water. Ensure the basin is filled with enough water. Another possible cause is lateral friction due to runout; try guiding the workpiece through the cutting wheel more slowly.
What to do if my Kobalt KWS B72-06 motor runs but the cutting disk remains still?
If the motor of your Kobalt Saw runs but the cutting disk remains still, the arbor nut may be loose. Check that the inner and outer washers are seated correctly, and then tighten the arbor nut if needed.
How to fix difficult material cutting with my Kobalt KWS B72-06 Saw?
If you're finding it difficult to cut materials with your Kobalt Saw, the tile cutting wheel may be dull. Consider replacing the cutting wheel.
General| Model Number | KWS B72-06 |
|---|---|
| Type | Circular Saw |
| Amperage | 15 Amps |
| Voltage | 120 V |
| Corded/Cordless | Corded |
| Power Source | Corded |
| Bevel Capacity | 56 degrees |
| Blade Diameter | 7-1/4 inches |
| Blade Size | 7-1/4 inches |
Details the technical specifications of the 7-in tabletop tile saw.
Lists all parts included in the product packaging for assembly.
Details the specific hardware components included for assembly.
Provides essential precautions for safe operation and handling.
Critical steps and checks to perform before operating the saw.
Guidelines for maintaining a safe work environment during operation.
Specific safety rules pertinent to the tile saw, including apparel.
Instructions for safely storing and transporting the tile saw.
Identifies potential hazards that may remain even with proper use.
Emphasizes the necessity of wearing safety goggles and ear protection.
Recommends using a dust mask due to potential hazardous dust.
Guidance on positioning the saw to prevent electrical hazards.
Crucial electrical safety precautions and grounding instructions.
Steps for safely unpacking the tile saw from its packaging.
Instructions for mounting the saw to a workbench or stand.
Step-by-step guide for securely installing the cutting wheel.
Instructions for attaching the blade guard assembly to the saw.
Steps for installing the rear water tray and overflow drain.
Instructions for assembling and locking the sliding table.
Instructions for attaching and securing the miter guide.
Lists the intended uses and types of materials for the tile saw.
Explains the operation of the power switch and its locking feature.
Instructions for filling and changing the water reservoir.
Instructions for locking and unlocking the sliding table.
How to adjust and use the miter guide for angled cuts.
General advice and techniques for making accurate tile cuts.
Guides for performing cross, diagonal, miter, L-cut, and bevel cuts.
Steps to align the sliding table square to the cutting blade.
Procedures for cleaning the saw components and lubrication advice.
Solutions for common problems encountered during operation.
Details of the three-year limited warranty for the tile saw.
List of available replacement parts and how to order them.
