28
CLOSING/EXTENDING THE STAND
(FIG. 22, 23, 24, 25, 26)
● Remove water catch trays and any
workpieces from the tool.
● Lower the wheel and secure by locking the
cutting head in place using the cutting head
lock knob (MM) and hold-down latch (SS).
(Fig. 22)
To close the stand (Fig. 22, 23):
● Step on the foot release lever (BB) and grasp
left and right handles (O & P) simultaneously to
lift them up and away from the body. (Fig. 22)
● Push the saw until the foot release lever (BB)
clicks and locks into place. (Fig. 23)
To move the stand (Fig. 24):
● Holding the left and right handles (O & P)
rmly, pull the handles toward you until
the stand and saw are balanced on the
wheels (CC).
● Push the saw to the desired location then
either open the stand for saw operation or
store the saw in a dry environment.
22
23
BB
MM
SS
BB
P
O
O
P
24
CC
O
P
To Next Page
Loading...
