kobalttools.com
8
OPERATING INSTRUCTIONS
7. Connect air supply to the air inlet (E) on
8.
proper
7
E
Nail direction
into flooring
6
8
6
(See Figure 7)
add 2 - 3 drops of pneumatic tool oil(part L) to the air inlet
before each use.(See Figure 6)
Before
6.
fastener
angle. Make sure base (C) is firmly pressed against the
edge of the flooring. (See Figure 8)
NOTE: Make sure the base plate screws do not protrude
and that the proper safety equipmaent is worn. Keep hands
and other parts of the body away from the tool’s discharge
area when connecting the air supply. It is recommended
that you test fire a few fasteners into a piece of flooring to
ensure that the PSI is set correctly. The fasteners fired
should secure the flooring and not protrude. It is also
recommended to make sure that the proper fasteners are
being used for your specific flooring project.
To Next Page
Loading...
Need help?
General
