Kodak 5500 ALL-IN-ONE PRINTER - Startup

Getting Started
You can purchase a Two-sided Printing Accessory and other accessories for your printer at
www.kodak.com/go/accessories
.
To install the Two-sided Printing Accessory
1 Remove the door on the back of the printer by pressing in on the two latches and pulling out.
2 Insert the bottom of the duplexer into the printer and press the top in until it clicks.
You can control how long the printer waits before a sheet is flipped by the duplexer with the AiO Home
Center (See General Settings).
Startup
When you power on your Kodak EasyShare All-in-One, status information is displayed on the LCD. After
the startup is complete, the EasyShare AiO enters the Copy mode, unless a photo device is attached. If a
photo device is attached or memory card inserted, the EasyShare AiO enters Photo mode.
User’s Guide 15