Kodak EasyShare CX6445 - Installing the Custom Camera Insert

72
Chapter 9
Installing the Custom Camera Insert
A universal insert is pre-installed in the camera dock. It allows all Kodak
EasyShare CX/DX6000/7000 series and LS600/700 series cameras to use the
camera dock.
A custom insert is included with your camera. It provides a perfect fit for
your Kodak EasyShare CX6445 zoom digital camera.
Remove the Universal Insert
1 Place your thumbs against the front of the
universal insert. Press in and lift.
2 Lift the side edge of the insert, then remove
the insert from the dock.
3 Save the universal insert as a spare.
Install the Custom Insert
1 Position the custom insert so the cutout
lines up with the camera dock connector.
2 Fit the insert into the groove in the dock.
Snap it into place.
NOTE: To order a custom insert for your camera, visit
www.kodak.com/go/cx6445accessories.
Cutout
Connector