20 KODAK EKTAGRAPHIC III Slide Projector
Operation
Reinserting the
Lens
To reinsert the lens, push the focus knob up and position the lens gear teeth
on the lens barrel with the notch on the projector.
Using a Dissolve Control
One of the more common uses for a dissolve control is a simple two-projector
fade. This feature fades down the light beam in one projector, while changing
the image and fading up the light beam in the other projector. This eliminates
a dark-screen interval.
When using a dissolve control, you need to divide your slides into two trays
(odd- and even-numbered slides).
The dissolve control has two connectors that plug into the remote-control
receptacles in the rear of two projectors. Refer to your dissolve-control
operating manual for additional instructions and features.
See your dealer in Kodak products for more information on Kodak dissolve
controls.
Shutdown
To shut down,
• remove and store the tray
• slide the power switch to off
Your projector will remain warm for several minutes.
To Next Page
Loading...
