Kodak EKTASOUND 235 - Page 6

7"--7 --
Set the PRO J E C TI O N C O N T R O L at OFF'/'EEXCAD and the
Remove the
POWER CORD from its storage area in the
V O L U M E C O N T R O L fully counterclockwise.
back of the projector. Insert one end into the
P O W E R
R E C E P T A C L E on the back of the projector and the other
end into a 120
- volt, 60 Hz power outlet only. If you plug
your projector into a different electrical source, you
may damage the projector.
:
SPEAKER/HEADPHONE
I
PROJECT~N C O N T RO L
VOLUME CONTROL
ELEVATION
'1 WHEEL
POWER
RECEPTACLE