To Next PageTo Next Page
Need help?Do you have a question about the Kodak ESP 3200 and is the answer not in the manual?
General| Brand | Kodak |
|---|---|
| Model | ESP 3200 |
| Category | All in One Printer |
| Language | English |
Remove all shipping tape from the outside of the printer.
Lift the printer access door and remove interior shipping tape and foam.
Connect the power cord to the adapter, adapter to printer, and cord to power source.
Remove LCD film, press ON button, and select language.
Lift printer access door and carefully remove printhead from bag, avoiding contacts.
Place printhead into carriage at angle and push firmly until it snaps.
Remove black ink cartridge from bag and discard orange cap carefully.
Insert black and color ink cartridges into printhead and press until they click.
Open paper tray, extend extender, adjust guides, and insert fanned paper.
Move paper forward until it stops and adjust left paper-edge guide until it stops.
Press Start to begin the calibration process, which takes two to three minutes.
Load KODAK All-in-One Printer Software CD into drive and follow on-screen instructions.
Connect the USB cable to the printer and computer until installation is complete.
Load KODAK All-in-One Printer Software CD into drive and follow on-screen instructions.
Connect the USB cable to the printer and Macintosh computer.
Crucial warnings about liquid, temperature, ink, placement, and object insertion.
Precautions on controls, disassembly, power, extension cords, and environmental factors.
