Koden MDC-7925 - Page 5

MDC-7000/7900 Series A table of content
0092669002-07 iii
3.1.3.2 Scanner unit 12kW (RB808) .................................................................................... 3-10
3.1.3.3 Scanner unit 25kW (RB809) .................................................................................... 3-16
3.2 Interconnection diagram of cable............................................................................................... 3-22
3.3 Installation of the Display unit .................................................................................................... 3-23
3.3.1 Installation of MRD-108 .................................................................................................. 3-25
3.3.1.1 Tabletop mounting of MRD-108 ............................................................................... 3-25
3.3.1.2 Flush mounting for MRD-108 ................................................................................... 3-26
3.3.2 Installation of Operation unit ........................................................................................... 3-28
3.3.2.1 Flush mounting for Operation unit ........................................................................... 3-30
3.3.3 Installation of MRM-108 ................................................................................................. 3-31
3.4 Cable connection to a Display unit ............................................................................................ 3-32
3.4.1 Cable connection for MRD-108 ...................................................................................... 3-32
3.4.2 Connecting an External monitor ..................................................................................... 3-33
3.4.3 Connecting a VDR or External monitor & Failure alarm output ..................................... 3-33
3.4.4 Connecting a Gyro converter unit or THD ...................................................................... 3-34
3.4.5 Connecting a Gyro converter unit or THD using Junction box JB-35 ............................ 3-35
3.4.6 Connecting a JB-35 (Option) to Gyro, OTHER and Inter-switch data ............................ 3-36
3.4.7 AIS cable connection ...................................................................................................... 3-37
3.4.8 GPS compass connection .............................................................................................. 3-37
3.4.9 Cable connection for EPFS and SDME or Log .............................................................. 3-38
3.4.10 Cable connection for inter-switch ................................................................................. 3-39
3.4.10.1 Cable connection instructions for cross-over, dual and independent connection . 3-39
3.4.10.2 Cable connection for slave display used as a monitor .......................................... 3-40
Chapter 4 Setup after installation ............................................................................ 4-1
4.1 STARTUP menu .......................................................................................................................... 4-2
4.1.1 Tune adjustment (TUNE) ................................................................................................. 4-2
4.1.2 Heading adjustment (HL OFFSET) .................................................................................. 4-2
4.1.3 Transmitting delay time adjustment (TX DELAY) ............................................................. 4-3
4.1.4 Antenna height (ANT HEIGHT) ........................................................................................ 4-4
4.1.5 Antenna cable length (ANT CABLE) ................................................................................ 4-4
4.1.6 Main Bang Suppression (MBS) ........................................................................................ 4-4
4.1.7 Setup SEA (STC) curve.................................................................................................... 4-5
4.1.8 Function key usage .......................................................................................................... 4-6
4.1.9 RANGE ENABLE .............................................................................................................. 4-7
4.1.10 TIMES ENABLE ............................................................................................................. 4-9
4.1.11 LOGO ........................................................................................................................... 4-10
4.1.12 MOTOR HIGH SPEED ................................................................................................. 4-10
4.1.13 MOUSE SPEED ........................................................................................................... 4-11