Frothing Milk/Producing Steam to Heat Liquids
The steam wand can be used to froth milk and make hot beverages like drinking chocolate,
water or tea.
1. Remove the water tank and fill it with desired amount of water. The water level
should be between the “MAX” mark and the “MIN” mark in the tank. Re-insert the
tank into the appliance securely.
2. Connect the appliance to the wall socket.
3. Press the ON/OFF button to turn on the unit; the power indicator will illuminate in
red.
4. Press the pump control button, making sure the coffee/steam button is at the
highest position. When there is water flowing out, close the pump immediately.
5. Press down the coffee/steam button and wait for a moment. The appliance begins
to heat until the indicator illuminates green, signifying that the heating is finished.
6. Dip the steam wand into the liquid to be heated. If you want to froth milk, dip the
steam wand about 2 centimetres into the milk. Slowly turn the steam knob anti-
clockwise to start making steam.
7. When the desired result is achieved, you can turn the steam knob to the “O”
position.
8. To avoid the steam outlet being blocked after frothing milk each time, put an
empty jug under the steam wand, then turn on the steam knob and press the
pump control button to the lower position. The pump will begin operating. Once
the water has been flowing for 30 seconds, press the pump control button to the
higher position.
9. Let the components cool down completely, then rinse under running water. Ensure
the steam wand / nozzle is thoroughly cleaned after each use. Remove the nozzle
cover and rinse, while cleaning the internal nozzle with a wet towel.
10. Press and release the ON/OFF button to power the unit off.
Note: Please follow the instructions below if the steam outlet is blocked: turn the steam
knob to “O” position and let the coffee maker cool down for about half an hour. Poke the
steam outlet several times with a needle around 1mm in diameter. Finally, press the
coffee/steam button and turn on the steam knob to check if the appliance can produce
steam normally when the steam indicator (green) illuminates. Please contact Kogan.com if
the appliance cannot produce steam after operated as above.
Note: After steaming, allow the maker to cool down at least for 5 minutes before making
coffee again, otherwise a burnt odour may be noticeable in prepared coffee. If you want to
make coffee immediately: press and release the steam button and dip the steam wand into
a cup. Press the pump control button down and turn on the steam control knob; water will
flow out from steam wand. After the ready indicator dims, press and release the pump
control button, then turn the steam control knob to “O” position. When the ready indicator
illuminates, the appliance is prepared for making coffee once again.
Automatic Power off Function
The appliance will turn off automatically if there is no any operation within 29 minutes.
To Next Page
Loading...