Before first use
To ensure the first cup of coffee will taste excellent, you should rinse the coffee maker with
warm water as follows:
1. Pull out the water tank of the coffee maker. Pour water into the water tank; the
water level should not exceed the “MAX” mark in the tank. Re-insert the tank into
the coffee maker.
2. Set steel mesh into the metal funnel (without coffee in steel mesh), then put the
metal funnel under the metal funnel holder (see Fig.1) and turn it anticlockwise until
it is fixed tightly (see Fig.2 and Fig.3).
3. Place an espresso cup you have prepared on the drip plate. Make sure the steam
knob is at the “O” position.
4. Connect the plug to the wall socket and press the ON/OFF button to turn on the
unit. The power indicator will be illuminated in red.
5. Press down the pump control button; the pump will then pump water accordingly.
Close the pump by pressing the pump control button again.
6. Make sure the coffee/steam button is at the higher position. The appliance will
begin preheating until the coffee indicator illuminates in green, signifying that the
preheating is finished.
7. Press down the pump control button again and water will flow out.
Metal funnel
holder
Fig.2
Fig.3
Fig.1
Note:
As the appliance is not equipped with any cup or jug, always prepare your own jug or
cup before use.
To Next Page
Loading...