8. After water has flown for 1 minute, press the pump control button once more. Pour
out the water in each container then clean them thoroughly. The unit is now ready
to start brewing coffee.
Preheating
It is recommended to preheat the appliance before making coffee (including the funnel and
cup) so that the coffee flavour will not be influenced by cold surfaces.
1. Remove the water tank and fill it with desired amount of water. The water level
should be between the “MAX” mark and the “MIN” mark in the tank. Re-insert the
tank into the appliance securely.
2. Set the steel mesh into the metal funnel (without coffee in steel mesh), then put the
metal funnel under the metal funnel holder (see Fig.1) and turn it anticlockwise until
it is fixed tightly (see Fig.2 and Fig.3).
3. Place an espresso cup you have prepared on the drip tray.
4. Connect the appliance into power supply. Make sure the steam knob is at the "O"
position.
5. Press the ON/OFF button to turn on the unit; the power indicator will illuminate in
red. Make sure the coffee/steam button is at the higher position.
6. Press the pump control button to the lower position. When water is flowing out,
close the pump immediately by pressing the pump control button again to the
higher position. The purpose of the step is to pump the water from the tank into the
housing.
7. When the coffee indicator is illuminated in green, press down the pump control
button again. Hot water should now be flowing.
8. After water has flown for 20 seconds, press the pump control button. The
preheating will now have finished.
Note:
There may be noise when pumping the water for the first time. This is normal, as the
appliance is releasing the air within it. After about 20s, the noise will disappear.
To Next Page
Loading...