Section or
Publication
Reference*
Electrical System (DC Circuits)
Scheduled
Maintenance
Section, I/M
Scheduled
Maintenance
Section, I/M
ATS - Automatic Transfer Switch; Eng.
- Engine; Gen.
- Generator Set; I/M
- Installation M
anual; O/M
- Operation Manual;
M/M – Maintenance Manual; S/M
- Service Manual;
S/S - Spec Sheet; W/D
- Wiring Diagram Manual
† Have an authorized service distributor/dealer perform this service.
Replace the
inoperative switch.
Replace the inoperative switch.
Clean and retighten the connection.
Reduce the electrical load. See the generator set
installation manual for wattage specifications.
Inspect the exhaust system. Replace the
inoperative
exhaust system components.
†
Inspect the exhaust system. Tighten the loose
exhaust
system components.
†
Tighten all loose hardware.
Troubleshoot the engine ECM and/or sensors.
Reset the controller. If the
overspeed fault occurs
again, contact the distributor/dealer.
High exhaust temperature switch
inoperative.
High water temperature switch
inoperative.
Faulty ground
connection.
Exhaust system not securely installed.
Valve clearance incorrect.
Engine ECM and/or sensors.
Exercise run
time and/or
event records
inoperative
Displays error
message/locks
up
Excessive or
abnormal noise
Cranks but
does not start