Kohler 60RCL - Networking Status Submenu

TP-6810 7/16 43Section 3 RDC2 Controller Operation
3.17.1 Networking Status Submen u
The Networking Status submenu contains settings for
OnCuer Plus. See the OnCuer Plus Software
Operation Manual for information about the appropriate
network settings for OnCuer Plus.
If DHCP is enabled, IP parameters are not displayed. If
DHCP is disabled (i.e., if a static IP address is used), the
IP parameters are displayed.
To enable or disable DHCP and change the IP settings,
go to the Networking Configuration menu. See
Section 3.17.2.
tp6804
IP Address:
123.456.789.123
Gateway:
123.456.789.123
<---- Return
Subnet Mask:
123.456.789.123
DHCP:
Enabled
Ethernet Status:
Disconnected
DNS 1:
123.456.789.123
DNS 2:
123.456.789.123
OnCue Server:
123.456.789.123
OnCue Status:
Connected
Networking---->
Status
Networking---->
Information
Figure 3-18 Network Status Submenu