Kohler 65EOZDJ - Page 7

TT-1602 5/16
7
7. Install the bulkhead connection panel.
7.1 Connect the fuel-inlet line to the fuel-inlet opening
on the bulkhead connection panel.
7.2 Connect the fuel-return line to the fuel-return
opening on the bulkhead connection panel.
7.3 Connect the seawater hose to the seawater
connection on the bulkhead connection panel and
secure with a hose clamp (X-426-19).
7.4 Secure the bulkhead connection panel (GM86346
or GM88918) to the corner rails (GM86079) using
brackets (GM86091 qty. 2), bolts (X-6224-20
qty. 4) and nuts (X-6210-7 qty. 4). See Figure 12.
1. Brackets (GM86091 qty. 2), bolts (X-6224-20 qty. 4), and
nuts (X-6210-7 qty. 4)
2. Bulkhead connection panel (GM86346 or GM88918)
GM86016-
1
2
Figure 12 Secure Bulkhead Connection Panel to
Corner Rails
8. Top Rails and Bracket Installation
GM86016-
1. Rail (GM86078 qty. 2). See Figure 14 for bracket location.
2. Rail (GM86081 qty. 2)
3. Corner (GM86035 qty. 4) and screw (X-67-141 qty. 24)
1
1
2
3
Figure 13 Top Rail and Bracket Installation
8.1 Cut foam (GM87549 or GM88912) to length and
insert into the rails (GM86078 qty. 2 and GM86081
qty. 2). See Figure 14.
8.2 Position the rails (GM86078 qty. 2 and GM86081
qty. 2) as shown in Figure 13.
8.3 Attach the brackets (GM86091 qty. 5) to the
service side rail (GM86081) using the hardware
specified at the locations shown in Figure 14.
8.4 Attach the brackets (GM86091 qty. 4) using the
hardware specified at the locations shown in
Figure 14.
8.5 Secure the corners (GM86035 qty. 4) to the rails
as shown in Figure 13 using six screws
(X-67-141) per corner.
8.6 Position the corner foam (GM87547 or GM88910)
as shown in Figure 14. Install three foam pieces
per corner.