What to do if the impeller on my Kohler 6EFKD-Low CO Portable Generator is damaged?
- CChelsea OlsenAug 9, 2025
If the impeller of your Kohler Portable Generator is damaged, replace the impeller and check the upstream system.
What to do if the impeller on my Kohler 6EFKD-Low CO Portable Generator is damaged?
If the impeller of your Kohler Portable Generator is damaged, replace the impeller and check the upstream system.
What to do if my Kohler 6EFKD-Low CO has an engine overload?
If your Kohler Portable Generator experiences an engine overload, reduce the electrical load. Refer to the generator set installation manual for specific wattage details.
What to do if my Kohler 6EFKD-Low CO Portable Generator battery is weak?
If your Kohler Portable Generator has a weak or dead battery, recharge or replace the battery. Consult the spec sheet for the recommended battery CCA rating.
Fuel Type | Gasoline |
---|---|
Rated Output (Watts) | 6000 |
Starting Watts | 7500 |
AC Output | 120/240V |
DC Output | 12 V 8 A |
Low CO Technology | Yes |
Engine | 4-stroke OHV |
Run Time at 50% Load | 14 hours |
Outlets | 4x 120V 20A, 1x 120/240V 30A |
Starting Method | Electric/Recoil |
Engine Type | 4-stroke OHV |
Starting System | Electric/Recoil |
Noise Level | 68 dBA at 23 feet |
Record product identification numbers from the generator set nameplate.
Record product identification information from the engine nameplate.
Essential safety guidelines for operation and maintenance.
Procedures for preparing and inspecting the generator set before operation.
Description of the controller interface, menus, and status indicators.
Step-by-step instructions for starting and stopping the generator set.
Understanding generator set fault codes, warnings, and reset procedures.
Overview of general maintenance practices and the service schedule.
Guidance on oil specifications, checks, additions, and changes.
Information on fuel specifications, filter replacement, and bleeding.
Maintenance for heat exchangers, pumps, flow switches, and anodes.
Spark plug service, battery care, and generator storage procedures.
Introduction to troubleshooting procedures and diagnostic methods.
Table of common symptoms, likely causes, and recommended actions.
Safety precautions and detailed point-to-point and schematic diagrams.
A glossary of abbreviations used throughout the manual.
Template for recording generator set operating hours and service history.