Product Information
Applicable product:
Bath with airjets (not shown) K-1174-G
Bath with airjets and chromatherapy (shown) K-1174-GCR
Fixture*:
Bathing well:
Basin area, bottom 45-3/4″ (116.2 cm) x 32″ (81.3 cm)
Basin area, top 66″ (167.6 cm) x 36″ (91.4 cm)
Weight 110 lbs (49.9 kg)
To overflow:
Water depth 19″ (48.3 cm)
Capacity 139 gal (526.2 L)
* Approximate measurements for comparison only.
Drop-in cutout 70-1/2″ (179.1 cm) x 40-1/2″ (102.9 cm)
Blower
motor/control:
Heater V Hz A
300 W 220-240 50/60 3
Required accessories:
Bath drain K-7272
Optional accessories:
Undermount kit K-592
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current
Device (RCD):
Blower motor/control: 220-240 V, 15 A, 50/60 Hz
Notes
Install this product according to the installation guide.
Floor support under bath must provide for a minimum of 42
lbs/square foot (204 kg/square meter) loading.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
A blower motor/control access panel is required.
Fixture dimensions are nominal and conform to tolerances in ANSI
Standard Z124.1.2.
21"
(53.3 cm)
1-1/2"
(3.8 cm)
36" (91.4 cm)
72" (182.9 cm)
42" (106.7 cm)
2-1/4"
(5.7 cm)
1"
(2.5 cm)
23"
(58.4 cm)
2-1/2"
(6.4 cm)
1/2" (1.3 cm)
No change in measurements if connected with
required drain illustrated. (K-7272)
1-1/2" OD
Blower/Control Access
34" (86.4 cm) W x
15" (38.1 cm) H Max
1087300-1-A 2 Kohler Co.
To Next Page
Loading...
