Kohler Comand Pro CH1000

1.11
Section 1
Safety and General Information
1
Fan/Flywheel
Fan Fastener Torque........................................................................................ 9.9 N·m (88 in. lb.)
Flywheel Retaining Screw Torque ................................................................ 67.8 N·m (50  . lb.)
Grass Screen
Hex Stud Torque ............................................................................................. 9.9 N·m (88 in. lb.)
Mounting Screw Torque ................................................................................. 9.9 N·m (88 in. lb.)
Front Drive Sha Screw Torque (Into Flywheel) ........................................ 24.4 N·m (216 in. lb.)
Governor
Governor Cross Sha -to-Crankcase Running Clearance .......................... 0.025/0.087 mm (0.0009/0.0034 in.)
Governor Cross Shaft O.D.
New ............................................................................................................ 7.963/8.000 mm (0.3135/0.3149 in.)
Max. Wear Limit ....................................................................................... 7.936 mm (0.3124 in.)
Governor Gear Sha -to-Governor Gear Running Clearance ................... 0.070/0.160 mm (0.0027/0.0063 in.)
Governor Gear Sha O.D.
New ............................................................................................................ 5.990/6.000 mm (0.2358/0.2362 in.)
Max. Wear Limit ....................................................................................... 5.977 mm (0.2353 in.)
Governor Lever Nut Torque .......................................................................... 7.3 N·m (65 in. lb.)
Ignition
Spark Plug Type (Champion
®
or Equivalent) ............................................. XC10YC
Spark Plug Gap ................................................................................................ 0.76 mm (0.030 in.)
Spark Plug Torque........................................................................................... 24.4-29.8 N·m (18-22  . lb.)
Ignition Module Air Gap ............................................................................... 0.28/0.33 mm (0.011/0.013 in.)
Ignition Module Fastener Torque ................................................................. 6.2 N·m (55 in. lb.) into new holes, or
4.0 N·m (35 in. lb.) into used holes
Lifter Feed Chamber
Cover/Baffl e Screw Torque ............................................................................ 6.2 N·m (55 in. lb.)
Muffl er
Muffl er Retaining Nut Torque....................................................................... 24.4 N·m (216 in. lb.)
Oil Cooler
Mounting Screws Torque ............................................................................... 3.9 N·m (35 in. lb.)
Oil Filter
Oil Filter Torque .............................................................................................. Refer to the oil fi lter for instructions
Oil Filter Adapter/Housing
Mounting Screw Torque ................................................................................. 24.4 N·m (216 in. lb.)