2.2
Section 2
Tools & Aids
Tools (cont.)
Description Source/Part No.
Flywheel Strap Wrench
To hold fl ywheel during removal.
SE Tools KLR-82409
Hydraulic Valve Li er Tool
To remove and install hydraulic li ers.
Kohler 25 761 38-S
Ignition System Tester
For testing output on all systems, except CD.
For testing output on capacitive discharge (CD) ignition system.
Kohler 25 455 01-S
Kohler 24 455 02-S
Off set Wrench (K & M Series)
To remove and reinstall cylinder barrel retaining nuts.
SE Tools KLR-82410
Oil Pressure Test Kit
To test and verify oil pressure.
Kohler 25 761 06-S
Rectifi er-Regulator Tester (120 volt current)
Rectifi er-Regulator Tester (240 volt current)
Used to test rectifi er-regulators.
Kohler 25 761 20-S
Kohler 25 761 41-S
Individual Components Available
CS-PRO Regulator Test Harness
Special Regulator Test Harness with Diode
Design Technology Inc.
DTI-031
DTI-033
Spark Advance Module (SAM) Tester
To test the SAM (ASAM and DSAM) on engines with SMART-SPARK
™.
Kohler 25 761 40-S
Starter Brush Holding Tool (Solenoid Shi )
To hold brushes during servicing.
SE Tools KLR-82416
Starter Retaining Ring Tool (Inertia Drive)
To remove and reinstall drive retaining rings (excluding FASCO starters).
Kohler 25 761 18-S
Starter Servicing Kit (All Starters)
To remove and reinstall drive retaining rings and brushes.
SE Tools KLR-82411
Individual Component Available
Starter Brush Holding Tool (Solenoid Shi )
SE Tools KLR-82416
Tachometer (Digital Inductive)
For checking operating speed (RPM) of an engine.
Design Technology Inc.
DTI-110
Vacuum/Pressure Tester
Alternative to a water manometer.
Kohler 25 761 22-S
Valve Guide Reamer (K & M Series)
For sizing valve guides a er installation.
SE Tools KLR-82413
To Next Page
Loading...
