11.18
Section 11
Reassembly
Figure 11-65. Tighten Baffle Mounting Screws.
6. The metal grass screen can now be attached to
the supports.
Figure 11-64. Tighten Short Screws to Torque
Specified.
Figure 11-66. Installing Metal Type Grass Screen.
7. Torque the four breather cover screws to 7.3 N·m
(65 in. lb.) in the sequence shown in Figure
11-67.
4. If the rectifier-regulator was not removed, attach
the ground wire or metal grounding bracket for the
rectifier-regulator, using the silver colored screw
and washer, to the lower blower housing hole.
See Figure 11-63.
Figure 11-63. Ground Lead Details.
5. Tighten all of the shrouding fasteners. Torque the
blower housing screws to 6.2 N·m (55 in. lb.) in a
new hole, or to 4.0 N·m (35 in. lb.) in a used hole.
Torque the shorter M5 side baffle screws to 4.0
N·m (35 in. lb.). See Figure 11-64. Torque the
upper M5 side baffle screws (into cylinder head)
to 6.2 N·m (55 in. lb.) in a new hole, or to 4.0 N·m
(35 in. lb.) in a used hole. Torque the two rear M6
baffle mounting screws to 10.7 N·m (95 in. lb.) in
a new hole, or to 7.3 N·m (65 in. lb.) in a used
hole. See Figure 11-65.
To Next Page
Loading...
