9.13
Section 9
Disassembly
9
Figure 9-45. Removing Flywheel Fastener Using
Strap Wrench.
2. Remove the hex. flange screw and washer.
3. Use a puller to remove the flywheel from the
crankshaft. See Figure 9-46.
NOTE: Always use a flywheel puller to remove
the flywheel from the crankshaft. Do not
strike the crankshaft or flywheel, as
these parts could become cracked or
damaged. Striking the puller or
crankshaft can cause the crank gear to
move, affecting crankshaft endplay.
Figure 9-48. Removing Stator.
Remove Oil Pan Assembly
1. Remove the ten hex. flange screws securing the
oil pan to the crankcase. See Figure 9-49.
Figure 9-46. Removing Flywheel with a Puller.
4. Remove the woodruff key.
Remove Stator and Backing Plates
1. Remove the four screws securing the backing
plates and stator wire bracket (if so equipped).
See Figure 9-47. Remove the backing plates and
stator wire bracket.
Figure 9-47. Removing Backing Plates and Stator
Wire Bracket.
2. Remove the two hex. flange screws and the
stator. See Figure 9-48. Note the position/routing
of the stator lead.
Figure 9-49. Removing Oil Pan Fasteners.
Splitting
Tabs
Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
