Kohler Command PRO ECH650 - Remove Oil Sentry; Remove Oil Temperature Sensor; Remove Inner Baffles and Breather Cover

8.9
Section 8
Disassembly
8
Figure 8-34. Removing Outer Baffl es.
6. Remove the remaining hex fl ange screws
securing the blower housing. Remove the blower
housing. See Figure 8-35.
Figure 8-36. Removing Oil Sentry™ Lead.
2. Remove the Oil Sentry™ switch from the
breather cover.
NOTE: This is optional. Removing the Oil Sentry™ is
not required to remove the breather cover.
Remove Oil Temperature Sensor
1. Disconnect the lead from the oil temperature
sensor. See Figure 8-37.
5. Remove the outer baffl es. See Figure 8-34.
Figure 8-35. Removing Blower Housing.
Remove Oil Sentry™
1. Disconnect the lead from the Oil Sentry™ switch.
See Figure 8-36.
Figure 8-37. Removing Oil Temperature Sensor
Lead.
2. Remove the oil temperature sensor from the
breather cover.
NOTE: Unless the oil temperature sensor is damaged
or malfunctioning, disassembly from the
breather cover is unnecessary.
3. Remove the breather hose from the breather
cover.
Remove Inner Baffl es and Breather Cover
1. Remove the two hex fl ange screws securing the
inner baffl es to the crankcase.
2. Remove the inner (valley) baffl es. See Figure 8-38.
Figure 8-38. Removing Inner (Valley) Baffl es.