1.12
Section 1
Safety and General Information
Ignition
Spark Plug Type (Champion
®
or Equivalent) ............................................. RC12YC, XC12YC, or Platinum 3071
Spark Plug Gap ................................................................................................ 0.76 mm (0.030 in.)
Spark Plug Torque........................................................................................... 24.4-29.8 N·m (18-22 . lb.)
Ignition Coil Fastener Torque ........................................................................ 10.2 N·m (90 in. lb.)
Cranksha Position Sensor Screw Torque ................................................... 6.2 N·m (55 in. lb.)
Cranksha Position Sensor Bracket Screw Torque .................................... 7.3 N·m (65 in. lb.)
Cranksha Position Sensor Air Gap ............................................................. 0.2-0.7 mm (0.008-0.027 in.)
Electronic Control Unit Screw Torque ......................................................... 6.2 N·m (55 in. lb.)
Intake Manifold
Intake Manifold Mounting Fastener Torque
Torque in Two Stages .............................................................................. fi rst to 7.8 N·m (69 in. lb.)
fi nally to 10.5 N·m (93 in. lb.)
Manifold Absolute Pressure (MAP) Sensor Fastener Torque ................... 7.3 N·m (65 in. lb.)
Fuel Injector Cap Torque ................................................................................ 7.3 N·m (65 in. lb.)
Air Cleaner to Thro le Body Fastener Nut Torque .................................... 8.2 N·m (73 in. lb.)
Heavy-Duty Air Cleaner Mounting Bracket Fastener Torque .................. 5.8 N·m (51 in. lb.)
Muffl er
Muffl er Retaining Nut Torque....................................................................... 27.8 N·m (246 in. lb.)
Oxygen Sensor Torque ................................................................................... 50.1 N·m (37 . lb.)
Oil Filter
Oil Filter Torque .............................................................................................. refer to the oil fi lter for instructions
Oil Cooler
Oil Cooler/Adapter Nipple Torque .............................................................. 28.5 N·m (21 . lb.)
Oil Cooler Fastener Torque
Into Blower Housing ............................................................................... 2.8 N·m (25 in. lb.)
Between Oil Cooler Hoses ...................................................................... 2.3 N·m (20 in. lb.)
To Next Page
Loading...
Need help?
General
