Kohler Command PRO ECH740 - Remove Fuel Injectors

8.11
Section 8
Disassembly
8
Figure 8-47. Disconnecting Electrical Connector.
2. Remove the hex fl ange screw and pull the injector
out of the intake manifold for each injector. See
Figure 8-48.
Figure 8-44. Disconnecting Electrical Connector.
Remove the Manifold Absolute Pressure
(MAP) Sensor
1. With a screwdriver, slide the locking tab on the
electrical connector. See Figure 8-45.
Figure 8-46. Removing MAP Screw.
Electrical
Electrical
Connector
Connector
Remove Fuel Injectors
1. Disconnect the electrical connector. See Figure 8-47.
Slide
Slide
Locking
Locking
Tab
Tab
Figure 8-45. Slide Locking Tab on Connector.
2. Detach the connector.
3. Remove the hex fl ange screw and pull the MAP
sensor out of the intake manifold. See Figure 8-46.
Figure 8-48. Removing Fuel Injectors.
3. When removed, pull the metal retaining clip
connecting the fuel injector to the fuel injector
cap. See Figure 8-49. There may be some fuel le
in the line. Any spilled fuel must be cleaned up
immediately.