10.24
Section 10
Reassembly
Figure 10-91. Install Oil Cooler.
Figure 10-90. Setting Governor Adjustment.
Install Muffl er
1. Install the port liners (if equipped). Install
exhaust gaskets and the muffl er. Install the
oxygen sensor, torque to 50.1 N·m (37 . lb.), and
connect to wire harness.
2. Install remaining muffl er support hardware
(screws and nuts) and torque to 9.9 N·m
(88 in. lb.).
3. Install the hex fl ange nuts to the exhaust studs.
Torque hex fl ange nuts to 27.8 N·m (246 in. lb.).
Install Oil Cooler
1. Secure the adapter to the oil pan with the oil fi lter
nipple. Torque the oil fi lter nipple to 28.5 N·m
(21 . lb.).
2. Verify all fuel and vent hoses are routed properly
and not pinched. Install the two hex fl ange
screws to secure the oil cooler to the blower
housing. Torque the top screw to 2.8 N·m
(25 in. lb.) and the lower screw to 2.3 N·m
(20 in. lb.). See Figure 10-91.
Figure 10-89. Low-Profi le Air Cleaner and Bracket.
2. Install the air cleaner components as described in
Section 4.
Setting Initial Governor Adjustment
1. Move the governor lever toward the thro le body
as far as it will go (wide-open thro le) and hold
in position.
2. Insert a nail into the hole on the cross sha and
rotate the sha counterclockwise as far as it will
turn, then torque the hex nut to 7.1 N·m
(63 in. lb.). See Figure 10-90.
Figure 10-88. Torquing Base Mounting Nuts.
Bracket Screws
Base Screws
Bracket
To Next Page
Loading...
