10.10
Section 10
Reassembly
Figure 10-34. Cylinder Head Fastener Torque
Sequence.
Install Push Rods and Rocker Arms
NOTE: Push rods should always be installed in the
same position as before disassembly.
1. Note the mark or tag identifying the push rod as
either intake or exhaust and cylinder #1 or #2. Dip
the ends of the push rods in engine oil and install,
making sure that each push rod ball seats in its
hydraulic li er socket. See Figure 10-35.
Figure 10-33. Torquing Cylinder Head Screws.
4. Torque the hex fl ange screws in two stages; fi rst
to 22.6 N·m (200 in. lb.), then fi nally to 41.8 N·m
(370 in. lb.), following the sequence in Figure
10-34.
#1 #2
Figure 10-35. Install Push Rods in Their Original
Position.
2. Apply grease to the contact surfaces of the rocker
arms and rocker arm pivots. Install the rocker
arms and rocker arm pivots on one cylinder head,
and start the two hex fl ange screws.
3. Torque the hex fl ange screws to 11.9 N·m
(105 in. lb.). See Figure 10-36.
Figure 10-32. Torquing the Cylinder Head
Mounting Nuts (Stud Design).
Heads secured with hex fl ange screws:
2. Install a new cylinder head gasket (part number
facing up).
NOTE: Match the numbers embossed on the
cylinder heads and crankcase. See Figure
10-26.
3. Install the cylinder head and start the four hex
fl ange screws. See Figure 10-33.
To Next Page
Loading...
