10.13
Section 10
Reassembly
10
Figure 10-45. Torque Fuel Injector Cap Screw.
6. Push the electrical connector on the fuel injector
making sure a good connection is made.
7. Repeat steps 1 through 6 for the other fuel
injector.
Install Manifold Absolute Pressure (MAP)
Sensor
NOTE: Ensure all parts are clean, undamaged and
free of debris and make sure the electrical
connector has the seal in place.
1. Lightly oil the MAP sensor O-ring and push the
MAP sensor into the bore in the intake manifold.
2. Torque the hex fl ange screw to 7.3 N·m
(65 in. lb.). See Figure 10-46.
5. Install the fuel injector cap hex fl ange screw into
the intake manifold and torque to 7.3 N·m
(65. in. lb.). See Figure 10-45.
Figure 10-46. Torque the MAP Sensor Screw.
3. Push the electrical connector on the MAP sensor
making sure a good connection is made.
Install Crankshaft Position Sensor
NOTE: Ensure all parts are clean, undamaged and
free of debris and make sure the electrical
connectors have the seal in place.
1. Install the cranksha position sensor and bracket
assembly to the crankcase posts.
2. Snug the hex fl ange screws and check the air gap
of the sensor with a feeler gauge. It must be
0.20-0.70 mm (0.008-0.027 in.).
3. Torque the bracket screws to the crankcase to
4.0 N·m (35 in. lb.) into used holes or 6.2 N·m
(55 in. lb.) into new holes. See Figure 10-47.
Figure 10-47. Torque Crankshaft Position Sensor.
4. Push the electrical connector on the cranksha
position sensor making sure a good connection is
made.
Install Valve Covers
1. Make sure the sealing surfaces are clean.
2. Make sure there are no nicks or burrs on the
sealing surfaces.
3. Install a new O-ring in the groove of each cover.
4. Position the covers on the cylinder heads. Locate
the cover with the oil separator hole on the
number 1 cylinder. Install the four hex fl ange
screws in each cover and fi nger tighten.
5. Torque the valve cover fasteners to 6.2 N·m
(55 in. lb.) using the sequence shown in Figure
10-48.
To Next Page
Loading...
