常见问题排除
以下部分问题现象可通过指示灯闪烁情况识别。（参考“感应指示灯的各种闪烁情况”）
现 象 原 因 处理方法
无电池或电池装反(直流电)
无电源或接线有误(交流电)
感应范围内有其它物体
感应窗口较脏
接线端未插好、插错
不出水
（感应指示灯不闪烁）
感应指示灯闪烁
不出水
感应指示灯闪烁
出水量小
约1分钟以内不止水
（感应指示灯不闪烁）
角阀关闭
过滤装置堵塞
起泡器堵塞
角阀是否彻底打开
起泡器堵塞
过滤装置堵塞
水压太低
打开角阀
清洗起泡器
清洗过滤装置
检查供水系统
打开角阀
清洗
过滤装置
清洗起泡器
检查电池
检查总电源和接线情况
移开物体
清洁窗口
检查接线端
TROUBLE SHOOTING
Some trouble symptoms can be identified by the indicator's flashing.
Symptoms Probable Causes Corrective Action
No battery or battery installed in
reverse(DC). No power supply or
wrong connection. Object in sensing
range.Dirt on the sensing window
The connector does not connect well.
No water flow while
the indicator flashes
Water runs for longer than
1 minute without switching
off.
Open the angle valve
Clean aerator
Clean filter
Check the water supply system
Check the batteries
Check the power supply and the conncetion
Remove the object
Clean the sensing window
Check the connector
感应指示灯每2秒快速
闪烁1次而不出水
电池耗尽(直流电)
刚刚停电
(
交流电
)
直流或交流接线端接触不良
(
交流电
)
更换电池
检查总电源
重新连接接插件
No water flow
(Indicator not flashing)
The indicator flashes once
every 2 seconds with no
water flow.
Low water flow while the
indicator does not flash
Object in sensing range
Remove object
感应范围内有物体
移开物体
（
Refer to "Light Indicator Key"
）
如按以上操作仍未解除问题，请与销售商或科勒(中国)投资有限公司联
系。除安装更换电池外，请勿随意拆卸龙头其它部件。
Batteries are out of power
Powercut
DC or AC connector
may not connect well
Replace batteries
Check the power supply
Reconnect the connector of AC/DC transformer
Open the angle valve
Clean filter
Clean aerator
The stop valve is not open completely
The Aerator is blocked
The filter is blocked
The supply water pressure is low
The stop valve is closed
The filter is blocked
The Aerator is blocked
Please contact with distributor or Kohler China Investment Co., Ltd., if the trouble remains after above-mentioned actions are
taken.Please do not disassemble the other parts of the faucet freely except installing and replacing batteries.
To Next Page
Loading...
Need help?
General
