How to adjust the dryer air temperature on a Kohler toilet?
If the dryer air from your Kohler toilet is too hot, the air temperature might be set too high. Use the remote control to decrease the air temperature.
Why does my Kohler toilet flush unexpectedly?
If your Kohler toilet is flushing unexpectedly, the automatic flush feature is likely enabled. When automatic flush is enabled, the toilet will flush shortly after use. To disable automatic flush, refer to the “Enable/Disable Automatic Features” section.
General| Product Name | Kohler K-29777-PA-0 |
|---|---|
| Product Type | Toilet |
| Category | Toilets |
| Color | White |
| Material | Vitreous China |
| Depth | 28.5 inches |
| Water Consumption | 1.28 gallons per flush |
| Bowl Height | 16.5 inches |
| Flush Rate | 1.28 GPF |
| Single Flush | Yes |
| Rough-In Size | 12 inches |
| Bowl Shape | Elongated |
| ADA Compliant | Yes |
Connect only to a GFCI protected circuit to prevent electric shock.
Disconnect power before performing any servicing.
Avoid UV radiation exposure; ensure lamp is off before opening cover.
UV lamp replacement requires qualified personnel; do not bypass interlock.
Avoid moisture and ensure ventilation to prevent damage to electronics.
Do not apply power until plumbing is complete to avoid malfunction.
Do not apply excessive force to the spray wand.
Product contains thermal protectors; allow to cool before installation.
Improper use of the grounding plug can result in electric shock.
Guidelines for cord/plug repair or replacement by qualified personnel.
Consult an electrician if grounding instructions are unclear.
Ensure product is connected to an outlet with the same configuration as the plug.
Do not use an extension cord with the product.
Operates toilet features via paired remote control. See 'Remote Control Setup'.
Choose between 0.92 gal (3.5 L) or 1.32 gal (5 L) water per flush.
Includes cover sensor, occupancy sensor, and heated seat.
Conserves energy by reducing heated seat temperature when not in use.
Includes front/rear wash, dryer with adjustable air temperature.
Includes automatic nightlight in low lighting conditions.
Includes deodorizer, mist, wand rinse, wand cleaning, and cleaning mode.
Remote must be paired before use; only one remote per seat.
Ensure four AA batteries are correctly installed in the remote.
Move remote near seat; remove other controls from area.
Press/hold 'Dryer' on remote, then 'Front'/'Rear' on panel until beep/stop blinking.
Details on buttons for flush, cover, seat, deodorize, clean, dryer, and battery indicator.
Notes on setting adjustment and battery verification.
Adjust seat and water temperatures using specific buttons.
Controls for position, massage, rear wash, front wash, and stop.
Enable/disable automatic seat cover opening/closing.
Enable/disable automatic deodorizer activation.
Enable/disable automatic flushing after use.
Enable/disable automatic adjustment of seat/water temperature.
Enable/disable automatic 24-hour UV cleaning cycle.
Enable/disable automatic nightlight in low lighting.
Enable/disable energy saving by reducing seat temperature.
Enable/disable beeping indicator for prolonged seating.
Wand can be clogged; clean when spray performance reduces.
Wand extends for cleaning only when seat is unoccupied.
Extend wand, clean with brush/water, retract wand.
Automatic 24-hour cleaning cycle; lifting cover ends process.
Do not insert fingers/objects into cavity during replacement.
Replace deodorizer every 2 years or when performance decreases.
Steps to remove old block, insert new block, and reassemble.
Steps to remove, rinse, and reinstall the screen.
Steps to remove remote from docking station, replace batteries, and reattach.
Covers start-up sequence and sensor detection for small children.
Addresses issues like no power, beeping, no response, and nightlight.
Addresses toilet not flushing and potential remote control issues.
Covers auto flush, seat heating, and cover open/close problems.
Addresses spray wand water flow and unexpected stops.
Covers wand movement, dryer heat, deodorizer, and beeping issues.
Addresses remote not turning on or connecting to the toilet.
Details FCC ID, IC compliance, and RF exposure guidelines.
To Next Page