7. Installation Checkout
Plug the power cord into the electrical outlet. The seat will go
through a power-up sequence, during which you will hear the
tank fill. The seat will go silent when the power-up is complete.
NOTE: You may also test the functions while sitting on the bidet
seat or covering the wand with your hand. Covering the seat with
plastic wrap is optional.
Wrap the toilet seat with plastic wrap. This will prevent water
from spraying from the toilet during testing.
Face the toilet, then place your hand or a damp wash cloth on the
right side of the seat approximately one-third the way back from
the front of the seat (as illustrated).
Proceed to the ″Using the Manual Controls″ and “Using the
Remote Control” sections in the Homeowners Guide to test the
various seat functions.
Kohler Co. 11 1194356-2-A
To Next Page
Loading...
Need help?
General
