Before You Begin (cont.)
If possible, flush all piping thoroughly before installing the valve to prevent clogging the inlet
filters. If the valve is installed when the pipes are flushed, clean the inlet screens before using the
system.
This valve is not intended for single-outlet use.
A qualified electrician should install a 120 V GFCI electrical outlet, within the stud framing, in close
proximity to the digital mixing valve.
If possible, install the electrical outlet prior to installing the valve.
This valve complies with UL1951, ASME A112.18.1, ASSE 1016, CSA B125, and CSA C222 No.
218.2-93. This valve is listed with ASSE, IAPMO/cUPC, and UL.
Kohler Co. reserves the right to make revisions in the design of faucets without notice, as specified
in the Price Book.
Kohler Co. 5 1145587-2-A
To Next Page
Loading...
Need help?
General
