Kohler Co.71274372-A05-B June 2016
Press this button to adjust wand position.
N – Dryer
Press this button once to activate dryer function after seating; press this button again to adjust dryer dials. Function will
O – UV Sterilization
Press this button to enter UV sterilization function under unseated status. Icon will blink.
P – Water Pressure
Press this button to adjust water pressure dials when front wash or rear wash is activated.
Low-Voltage Warning
Note: Please charge immediately after voltage warning.
•
When button blinks, this indicates remote internal battery will be exhausted, the remote requires charging.
Pairing
Note: Pairing process shall only be performed when unseated.
•
Press remote top ON button to activate toilet when under normal powered on status.
•
Hold remote dryer button, after bottom row of icons quick blinking, toilet operation starts.
•
Hold toilet button and button on toilet side panel, release button when heard one short beep.
•
When the bottom row of icons on remote stop blinking, this indicates successful pairing.
Remote to Toilet Communication
Stop Function
•
Whenever pressing and holding button, remote shall enter stop mode.
Remote Setting Guide
•
When remote moves outside of detection area, bottom row of icons on remote will auto flash (indicating searching toilet
signal). When moved back into toilet detection area, if toilet is powered on and under normal operation, signal will be
automatically reconnected, and icon will stop blinking after successful connection.
M – Wand Move
UV
spiral 旋转冲洗
cover 便盖
seat 座圈
massage 脉冲/移动
B
G
H
DC
I
J
F
N
O
E
P
M
L
K
stop automatically after about 4 minutes or can be turned off immediately by pressing the OFF button.
To Next Page
Loading...
Need help?
General
