Kohler Co.91274372-A05-B June 2016
Preparation Before Initial Use
Connect to power supply
Power switch ON
(indicating LED ON)
Confirm power switch is ON and inlet valve is OPEN by opening side panel.
Confirm no obstruction in front of the product.
When power is ON, wait until toilet completes self checking. It is normal to hear motor rotation and water flow sounds
as well as seeing the night light blinking during this process. When night light stops blinking, self-checking procedure
is complete.
Default status settings for initial use:
Front wash:
Water temp: mid
Water flow: mid
Wash position: 3rd dial
Rear wash:
Water temp: mid
Water flow: mid
Washing position: 3rd dial
Spiral：
Water temp: mid
Water flow: mid
Washing position: 3rd dial
Seat temp: mid
Wind temp: mid
Night light: ON
Energy saving: OFF
Auto cover swing function: ON; distance: mid Auto
flush function: ON
Auto UV function: ON
E-water function: ON
Deodorizing: ON
Confirm "remote" battery is installed correctly.
Angle valve ON
Connect to water inlet valve
To Next Page
Loading...
Need help?
General
